Easy way to employ a Drug Test.
This text is going to debate the commonest sort of drug test, the “Dip Test”. Dip drug tests come in one to twelve panel test configurations. An one panel test will test for one drug at a time, a 2 panel tests for two drugs at a time, for example. Most dip tests come individually packed in foil pouch ( one test per pouch ). Complete instructions one. Permit the test panel and piss sample to equilibrate to room temperature ( 15-30C ) before testing.Bring the pouch to room temperature before opening it. Take away the test panel from the sealed pouch and use it as quickly as possible. Two. Take off the cap outside the test end. With arrow ( s ) pointing toward the piss sample, immerse the test panel vertically in the piss sample for a minimum of 10-15 seconds.
Don’t pass the arrows on the test panel when immersing the panel. The same process is followed for a multi-panel test card. Three. Place the test panel on a non-absorbent leveled surface, start the timer and wait for the coloured line ( s ) to appear.
The results should be read at five mins. Don’t interpret results after ten mins. Please note : dip test tests provide only an initial analytical test result. A more certain alternative chemical system need to be used to get a confirmed analytical result. Gas chromatography / mass spectrometry ( GC / MS ) has been revealed as the preferred confirmatory system by the nation’s Institute on substance abuse ( NIDA ).
Clinical consideration and professional judgment should be applied to any drug of abuse test result, especially when initial positive results are indicated.
INTERPRETATION OF RESULTS NEGATIVE:* 2 lines appear. One coloured line should be in the control area ( C ), and another obvious coloured or a faded color line opposite should be in the test area ( T ).
This negative result implies that the drug concentration is below the perceivable level.
NOTE : the shadow of the test line area ( T ) will vary, but it should be considered negative whenever there’s even a faint coloured line.
POSITIVE : One coloured line appears in the control area ( C ). No line appears in the test area ( T ). This positive result suggests that the drug concentration is above the detectable level.
INVALID : Control line fails to appear. Inadequate example volume or inaccurate procedural methodologies are the most probable reasons for control line failure. Review the process and repeat the test employing a new test panel. If the difficulty continues, can using the lot instantly and contact your local distributor.